JVC lt-26c50bu ユーザーズマニュアル

ENGLISH

LT-32/26C50BU/SU / LCT1700-001A-U / English

This TV can be used as a computer screen.

Use a D-SUB cable to connect the TV’s PC 
IN terminal to the computer’s analogue RGB 
output terminal.
If you want to listen to the sound from the 

computer, use an audio cable to connect the 
EXT-3 L/R terminal to the computer’s sound 
output terminal.

When the sound from the computer is mono, 
connect to the EXT-3 L terminal.

• Refer to the computer manual for a 

detailed explanation of the connections at 

the computer side.

• Ensure that the connectors are facing the 

correct way when connecting.

• After connecting the D-SUB cable, 

tighten the two screws to fix the connector 
in place.

G or p p buttons to choose “PC”

“PC” is after EXT-4.

You can listen to the sound when the 
sound from the computer is connected to 
the EXT-3 L/R terminal.

• When the sound from the computer is 

connected to EXT-3, by choosing 

external input EXT-3 the sound from 
the computer can be listened to, but the 
images from the computer cannot be 

seen.

* Only the above formats are supported.
* Even with the above formats and at 

60 Hz, some problems may be 

experienced depending on the quality of 

the synchronous signal. (Depending on 

the quality, some pictures may not be 

displayed properly.)

* Apple Macintosh

*

 computers are not 

supported.

When a picture is not displayed
Check the computer’s refresh rate and set it 
to 60 Hz. Refer to the computer’s instruction 

manual.
Computers which cannot have their refresh 
rate set to 60 Hz cannot be used with this 
unit.

* Apple Macintosh is a registered 

trademark of Apple Computer, Inc.

640 

× 480 

(VGA)

60.0

31.5

1024 

× 768 

(XGA)

60.0

42.0

LT-32&26C50BUSU_Eng.book  Page 45  Wednesday, July 28, 2004  2:20 PM