JVC lt-20da6ssp ユーザーズマニュアル

- 25 -

When OK button is pressed, following mes-

sage will appear on the right bottom side of

the screen:

35/LVW(PSW\

Manual Search:
This is for searching for digital channels on a

single broadcast frequency. The frequency

channel number (21-68) is entered in the box

at the top left of the screen and the received

signal level and signal quality can be observed

on the two bar graphs at the bottom. When OK

is pressed, the TV searches that frequency

and display a list of the channels found.

Hint
The bar graphs of signal quality and signal

level give a good indication of whether any

channels are likely to be found. If only the

signal level graph shows a high value then it

is likely that an analogue channel occupies

that broadcast frequency. If the signal qual-

ity bar is high as well then it is a digital fre-

quency and digital channels will probably

be found.
Again, channels which duplicate those already

in the channel list are ignored. However, the

manual channel search will find all channels

on the broadcast frequency.
When either search is finished, press the

MENU key to return to normal broadcast view-

ing, to watch the new digital terrestrial televi-

sion channels found.
Factory Settings:
To reset the TV, highlight the Factory Settings

line in the menu and press OK. A warning

screen is displayed in case of accidental op-

eration.

$UH\RXVXUH\RXZDQWWRGHOHWHWKH35OLVW

DQGUHVHWDOOVHWWLQJV"

<HV

Highlight the YES button with the or

key and press OK to erase all the channels

and settings. A message will be displayed on

the screen.

35/LVW(PSW\6WDUWDXWRPDWLFVHDUFK

Press the OK button to start the automatic

search.

When the automatic search has finished, the

EDIT PR LIST menu appears.

Common Interface

It is required to subscribe to a pay channel

company to view the pay channels of the Digi-

tal Terrestrial broadcasting.
Obtain the Conditional Access Module (CAM)

and the Viewing card by subscribing to a pay

channel company, then insert those to the Tele-

vision using the following procedure.
1. Switch off the TV and unplug from the mains.
2. Insert the CAM, then Viewing Card to the

slot that is located in the terminal cover at

the left-hand side of the TV (from front view).

The CAM should be correctly inserted, it is

impossible to insert fully if reversed. The

CAM or the TV terminal may be damaged if

the CAM is forcefully inserted.

3. Connect the TV to the mains supply, switch

on and then wait for few moments until

the card is activated.

Some CAMs may require the following set

up. Please set the CAM by entering the DTV

menu, Common Interface then pressing OK

button. (CAM set up menu is not displayed

when it is not required.)

To see the viewing contract information,

press MENU, Select DIGITAL and Press OK,

then Select Common Interface and press

OK.

01-ENG-20710W-17MB16P-C1897S UK-(LT-20DA6SSP)-(TVAVOK)-IDTV-10042117-5008XXXX.p65

15.06.2006, 17:39