Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. JVC
  4. TM-H1950CG
  5. ユーザーズマニュアル

JVC TM-H1950CG ユーザーズマニュアル

ダウンロード
ページ / 16
TM-H1950CG
1-7
No.51961
1. Turn off the Color Video Monitor’s main power and unplug the power cable
from the AC outlet.
2. Unscrew the screws and remove the slot cover from the slot (on the rear side
of the monitor) in which you are going to install the card.
3. Insert the Input Card’s board (green-colored) into the slot, fitting the board into
the guide rails on the top and bottom of the slot.
4. Push the Input Card in so that its front panel touches the monitor’s rear panel.
5. Secure the Input Card by replacing the screws removed in Procedure 2.
VIDEO A
REMOTE
SLOT
VIDEO B
IN
OUT
IN
IN
OUT
Y/C
INSTALLING THE INPUT CARD
Slot cover
Fit the board to
the guide rails.
Rear side of the TM-H1950CG
color video monitor
Knob
Input card (the illustration
shown is of the IF-C01COMG)
Guide rails
Knob
NOTE : Do not touch the terminal connected to the monitor or board pattern.
Do not remove slot covers from the monitor’s slots if they are not in use.
PREPARATION
8
VIDEO A
REMOTE
SLOT
VIDEO B
IN
OUT
IN
IN
OUT
Y/C
VIDEO A
REMOTE
SLOT
VIDEO B
IN
OUT
IN
IN
OUT
Y/C
ENGLISH
9
1. Attach the Power Cord Holder case to the AC inlet on the back of the monitor with 2 screws
(provided).
2. Attach the Power Cord Holder cover to the AC power cord.
3. Connect the AC power cord to the AC inlet, and join the Power Cord Holder cover with the
case.
ATTACHING THE POWER CORD HOLDER
The provided Power Cord Holder prevents the AC power cord from being accidentally disconnected from the AC inlet.
The Power Cord Holder consists of two parts; a case and cover.
Press the cover until it clicks.
Hold until it clicks.
Caution:
A different plug shape will result in the cover being
attached to a different position.  Check to make sure the
plug doesn't pull out after the cover is attached.
Note:
To disconnect the power cord, click the tab to open the
cover.
Caution:
Use only the provided screws.