packardbell dot m a サービスマニュアル
Chapter 3
85
LCD Module Reassembly Procedure
Replacing the Antennas
1.
Remove the protective covering on the left and right Antenna pads. Place the Antenna pads in the LCD
Module and press down to secure the adhesive in place.
Module and press down to secure the adhesive in place.
IMPORTANT: be sure the cables pass behind the shielding material as shown.
2.
Run the left side cable down the side and along the lower edge of the LCD Module using all the available
cable clips.
cable clips.
3.
Run the right side cable down the side of the LCD Module using all the available cable clips. Be sure the
cables pass behind the shielding material as shown.
cables pass behind the shielding material as shown.