BMW x5 2001 ユーザーズマニュアル

ページ / 223
Index
Data
Technology
Repairs
Car care
Controls
Overview
175
n
Lamps and bulbs
The lamps and bulbs are essential 
factors contributing to the safety of your 
vehicle. For this reason, follow the 
instructions below carefully when 
replacing a bulb. If you are not familiar 
with any of the procedures, consult 
your BMW center. 
Do not touch the glass portion of a 
new bulb with your bare hands 
since even small amounts of impurities 
burn into the surface and reduce the 
service life of the bulb. Use a clean 
cloth, paper napkin, or a similar mate-
rial, or hold the bulb by its metallic 
base.
<
 
A replacement bulb set is available from 
your BMW center. 
Whenever working on the elec-
trical system, switch off the elec-
trical accessory you are working on or 
disconnect the cable from the negative 
terminal of the battery. Failure to do this 
could result in short circuits. 
To prevent injuries and damage, 
comply with any instructions provided 
by the bulb manufacturer.
<
 
The illustration shows the right-hand 
engine compartment. 
For checking and adjusting head-
lamp aim, please contact your 
BMW center.
<
 
1 Low beams 
H7 bulb, 55 watts 
The bulb is pressurized. There-
fore, wear safety glasses and 
protective gloves. Failure to comply 
with this precaution could lead to injury 
if the bulb is accidentally damaged 
during replacement.
<
 
1 Turn the bulb holder to the left (arrow) 
and remove.
2 Remove and replace the bulb. 
530us107
2 High beams
HB3 bulb, 60 watts
The bulb is pressurized. There-
fore, wear safety glasses and 
protective gloves. Failure to comply 
with this precaution could lead to injury 
if the bulb is accidentally damaged 
during replacement.
<
 
1 Turn the bulb to the left and remove.
2 Disconnect the plug.
3 Plug the new bulb into the plug 
connector. Be sure that it is securely 
engaged.
4 Install in the opposite order. 
When cleaning the headlamps, 
please observe the following: 
>
Do not wipe dry (scratches). Never 
use abrasives or strong solvents to 
clean the covers. 
>
Remove dirt and contamination (such 
as insects) by soaking with BMW Car 
Shampoo and then rinsing with plenty 
of water. 
>
Always use a deicer spray to remove 
accumulated ice and snow – never 
use a scraper.
<
 
Online Edition for Part No. 01 41 0 155 558 - © 09/00 BMW Group