Yamaha aw1600 ユーザーズマニュアル

Using the input library

k recording

AW1600 Owner’s Manual

If you want to adjust the effect, use the
[INPUT SEL] key to select the input chan-
nel. While you produce sound on your
instrument, adjust the [EQ] knob, [DYN]
knob, or [EFFECT 1]/[EFFECT 2] knobs of
the Selected Channel section.

Immediately after you select an input library, turning
the knobs of the Selected Channel section will control
the following items.

• Turning the [EQ] knob

...........Adjusts the amount of boost/cut for each

EQ band. To select the band that will be
adjusted, use the [HIGH] key, [HI-MID] key,
[LO-MID] key, or [LOW] key located at the
right.

• Turning the [DYN] knob

...........Simultaneously adjusts multiple dynamics

parameters to adjust the dynamics effect.
The result will depend on the library that
you selected.

• Turning the [EFFECT 1] knob

...........Adjusts the balance of direct sound and pro-

cessed sound for internal effect 1.

• Turning the [EFFECT 2] knob

...........Adjusts the balance of direct sound and pro-

cessed sound for internal effect 2.

In the same way, select input library set-
tings for the other input channels.

However, a maximum of two input channels can use
the internal effects at the same time.

Input library

Internal effect

Dynamics

Speaker

simulator

INPUT LEVEL

to the bus

MIC/LINE

INPUT jack

Input channel

• If the input channel is paired, the same settings will be applied to both channels.

NOTE

• Depending on the input library you select, the level of the

input channel may change. Re-adjust the volume balance
using the INPUT LEVEL knob in the INPUT SETTING popup
window.

NOTE

• If turning the [EQ] knob or [DYN] knob does not produce the

desired result, you can reload new settings from the EQ
library or dynamics library (

→ p. 77, 78).

HINT