Yamaha DSP-A970 ユーザーズマニュアル
1
Audio Signal Connection Jacks (for Audio Source Equipment)
Connect the inputs and/or outputs of your audio equipment.
2
Audio/Video Signal Connection Jacks (for Video Source
Equipment)
Equipment)
Connect the audio and video inputs and/or outputs of your video
equipment. In place of the VIDEO jacks, the S VIDEO jacks can
be used for higher resolution and improved picture quality if your
VCR, monitor, etc. are equipped with S-VIDEO connectors.
equipment. In place of the VIDEO jacks, the S VIDEO jacks can
be used for higher resolution and improved picture quality if your
VCR, monitor, etc. are equipped with S-VIDEO connectors.
3
Front Effect Out Jacks
Front-channel line output. Not connected when the built-in
amplifier is used. Can be connected to input jacks of an external
stereo power amplifier driving the front effect speakers.
amplifier is used. Can be connected to input jacks of an external
stereo power amplifier driving the front effect speakers.
4
Rear Effect Out Jacks
Rear-channel line output. Not connected when the built-in
amplifier is used. Can be connected to input jacks of an external
stereo power amplifier driving the rear effect speakers.
amplifier is used. Can be connected to input jacks of an external
stereo power amplifier driving the rear effect speakers.
5
Main Speaker Terminals
When using this unit’s built-in main-channel amplifier, connect the
main speakers here.
main speakers here.
6
Front Effect Speaker Terminals
When using the built-in front-channel amplifier, connect the front
effect speakers here.
effect speakers here.
7
Center Speaker Terminals
When using the built-in center-channel amplifier, connect one or
two center speakers here.
two center speakers here.
8
Center Speaker Impedance Switch
Set to “A + B” when using two center speakers, or to “A or B”
when using only one center speaker.
when using only one center speaker.
9
Rear Effect Speaker Terminals
When using the built-in rear-channel amplifier, connect the rear
effect speakers here.
effect speakers here.
0
GND Terminal
Connects the ground wire of the turntable to produce minimum
hum. In some cases, however, better results may be obtained
with the ground wire disconnected.
hum. In some cases, however, better results may be obtained
with the ground wire disconnected.
A
Video NTSC/PAL Switch (General Model only)
Set this switch to the position corresponding to the standard
that your video equipment employs.
that your video equipment employs.
B
Front Mix Switch
Set to “OFF” when setting up a full 7 or 6 speaker system, or to
“ON” when setting up a 5 or 4 speaker system.
“ON” when setting up a 5 or 4 speaker system.
C
Main Level Switch
Normally set to “0 dB”. If desired, you can decrease the main-
channel output level at the MAIN speaker terminals by 10 dB by
setting this switch to “–10 dB”.
channel output level at the MAIN speaker terminals by 10 dB by
setting this switch to “–10 dB”.
D
Low Pass Jack
When using a subwoofer, connect its amplifier input to this jack.
Frequencies below 200 Hz from the left main, right main and
center channels are output to this jack.
Frequencies below 200 Hz from the left main, right main and
center channels are output to this jack.
11
English