Yamaha RXA830BL ユーザーズマニュアル

En

■

Speaker cables have two wires. One is for connecting the 
negative (–) terminals of the unit and the speaker, and the 
other is for the positive (+) terminals. If the wires are 
colored to prevent confusion, connect the black wire to 
the negative and the other wire to the positive terminals.

a Remove approximately 10 

mm (3/8”) of insulation 
from the ends of the 
speaker cable and twist 
the bare wires of the cable 
firmly together.

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side 

(upper right or bottom left) of the terminal.

d Tighten the terminal.

(U.S.A., Canada, China, 
Australia and General 
models only)

a Tighten the speaker 

terminal.

b Insert a banana plug into the end of the terminal.

Connect the front speakers (1/2) 
to the FRONT (//\) terminals.

Connect the center speaker (3) to the 
CENTER terminal.

• Under its default settings, the unit is configured for 8-ohm 

speakers. When connecting 6-ohm speakers, set the unit’s 
speaker impedance to “6 

Ω MIN”. For details, see “Setting the 

speaker impedance” in “Owner’s Manual”.

• Use a subwoofer equipped with built-in amplifier.

• Before connecting the speakers, remove the unit’s power cable 

from the AC wall outlet and turn off the subwoofer.

• Ensure that the core wires of the speaker cable do not touch 

each other or come into contact with the unit’s metal areas. This 
may damage the unit or the speakers. If the speaker cables 
short circuit, “Check SP Wires” will appear on the front display 
when the unit is turned on.

a

a

b

d

c

– (black)

+ (red)

a

b

Banana plug

1

2

3

4

5

9

The unit (rear)

1

2

3

4

5

9

The unit (rear)