Yamaha RX-V757 ユーザーズマニュアル
96
TROUBLESHOOTING
■
Tuner
Problem
Cause
Remedy
Refer to
page
There is noise
interference from
digital or radio
frequency equipment,
or this unit.
interference from
digital or radio
frequency equipment,
or this unit.
This unit is too close to the digital or high-
frequency equipment.
frequency equipment.
Move this unit further away from such equipment.
—
The picture is
disturbed.
disturbed.
The video source uses scrambled or
encoded signals to prevent dubbing.
encoded signals to prevent dubbing.
There is noise when
the OSD is displayed.
the OSD is displayed.
The OSD may be disturbed when
displaying OSD through component video
connections.
displaying OSD through component video
connections.
Select OFF in CMPNT OSD.
This unit suddenly
turns into the standby
mode.
turns into the standby
mode.
The internal temperature becomes too
high and the overheat protection circuitry
has been activated.
high and the overheat protection circuitry
has been activated.
Wait about 1 hour for this unit to cool down and then
turn it back on.
turn it back on.
—
Problem
Cause
Remedy
Refer
to page
FM
FM stereo reception is
noisy.
noisy.
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
There is distortion, and
clear reception cannot
be obtained even with a
good FM antenna.
clear reception cannot
be obtained even with a
good FM antenna.
There is multipath interference.
Adjust the antenna position to eliminate
multipath interference.
multipath interference.
—
The desired station
cannot be tuned in with
the automatic tuning
method.
cannot be tuned in with
the automatic tuning
method.
The signal is too weak.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Previously preset
stations can no longer
be tuned in.
stations can no longer
be tuned in.
This unit has been disconnected for a
long period.
long period.
Preset the stations again.
AM
The desired station
cannot be tuned in with
the automatic tuning
method.
cannot be tuned in with
the automatic tuning
method.
The signal is weak or the antenna
connections are loose.
connections are loose.
Tighten the AM loop antenna connections
and orient it for the best reception.
and orient it for the best reception.
—
Use the manual tuning method.
There are continuous
crackling and hissing
noises.
crackling and hissing
noises.
Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
fluorescent lamps, motors, thermostats
and other electrical equipment.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
This will help somewhat, but it is difficult to
eliminate all noise.
—
There are buzzing and
whining noises.
whining noises.
A TV set is being used nearby.
Move this unit away from the TV.
—