iOptron smartstar 8604 ユーザーズマニュアル

iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569‐0200 | Toll Free (866) 399‐4587 | www.iOptron.com 

 

 

1.  Extend tripod legs to full 

extension. 

2.  Slide tray on bottom of shaft 

(#7). Then screw on round 
black knob (#9). 

 

1.  Raise wedge plate on the tripod by turning two tilt 

locks (12); 

2.  Attach mount to wedge plate using supplied azimuth 

lock screw (10). 

3.  lower wedge plate to it’s lowest position by turning the 

upper tilt lock upward while lightly push the mount 
down. Secure the mount by tightening the lower lock. 

 
Note: you may use 8 AA batteries (Step 3a and 3b) or the AC 
adaptor (Step 5) to operate the mount. 
 

Carefully remove the battery compartment cover (shown) 
open. Gently pull the battery holder out of the 
compartment 

(see photo in Step 3b) 

to avoid breaking the 

attached wires.

Step 3b. 
Insert 8 AA batteries 

(not included) 

in the holder. Refer to the 

diagram on the holder to orient the batteries properly. Replace 
the holder back into the battery compartment and replace the 
lid. 
 

 

Attach telescope to mount using dovetail lock knob (#2). 
 
(Picture shows 80mm refractor. However all scopes will attach in 
the same manner.) 

#2 knob