ICOM rs-rp2c ユーザーズマニュアル

4

2

SYSTEM SETUP

■ Router settings

D

D IP address setting

Set the specified IP addresses for both WAN and LAN
as follows.

IP address (WAN) : Enter the fixed global IP address

that is specified from the ISP.

IP address (LAN) : 10.0.0.1

The same IP address (for LAN; 10.0.0.1) is used

for all gateways. NEVER use other private IP address.

D

D Port forwarding setting

Set the following port number with protocol to transfer-
ring to the IP address “10.0.0.2.”

NOTE: IP filter must be set to allowing Internet re-
mote access to local IP address “10.0.0.2.”
Otherwise the D-STAR gateway will not work due to
the firewall.

20005/TCP

IP server synchro-

PORT_SYNC

nization

(/etc/dsipsvd.conf)

40000/UDP Voice transfer

GW_VCPORT
(/etc/dsgwd.conf)

40001/TCP Data transfer

GW_DTPORT
(/etc/dsgwd.conf)

■ Sever settings

D

D LAN card settings

NOTE: The fixed value for both the IP address and
subnet mask must be set to both eth0 and eth1.
Otherwise the gateway server cannot communicate
to another D-STAR gateway.

q Open “Network Configuration” screen with the fol-

lowing mouse operation.

w Select [eth0] or [eth1] to select router or repeater

side respectively, then click [Edit].

• The “Ethernet Device” screen appears as right above.

e Select [Statically set IP address], then enter the

specified IP address, subnet mask and default
gateway 

(router side; eth0 setting only), as below.

Click [OK], then close “Ethernet Device” screen.

r Click [DNS] tub in “Network Configuration” screen,

then enter the address “127.0.0.1” (fixed value)
into “Primary DNS” column.

Click

Primary DNS: 
127.0.0.1

Click

Select

eth0: 10.0.0.2
eth1

: 172.16.0.20

eth0: 255.0.0.0
eth1: 255.255.255.0

eth0: 10.0.0.1
eth1: Blank

Displays the LAN card name
that is selected in steps w.

For router

Click

For repeater

z Click

c Click

x Select