Eagle Electronics intellimap 320 ユーザーズマニュアル
74
Make the desired settings, then turn the simulator on by highlighting
the
the
GPS S
IMULATOR
O
N
box and pressing
ENT
key. Press
EXIT
|
EXIT
|
EXIT
to erase this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the IntelliMap 320 off.
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the IntelliMap 320 off.
While in simulator mode, you can press
EXIT
to clear the steering and
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER WITH
A
RROWS
command, press
ENT
, then Press
EXIT
|
EXIT
|
EXIT
to return to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
S
TARTING
P
O-
SITION
at or near the beginning of your trail/route. Enter an approximate
T
RACK
(shown in compass degrees) that will point you toward the start
of the trail/route.
2. Set
S
PEED
to zero. Select
S
TEER WITH
A
RROWS
command and press
ENT,
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
EXIT
to clear the alarm.) When navigation starts,
press
↑ to increase speed to the desired setting.
4. Press
EXIT
to turn off the steering and speed boxes. The IntelliMap
320 will now automatically "steer" along the trail or route. When you
arrive at your "destination," cancel navigation as you normally do.
arrive at your "destination," cancel navigation as you normally do.
Tip:
You can pick any spot on the map to begin your simulation session
by using the Initialize GPS command. This makes your unit think
it's located at the position you select. See its entry following the en-
try for
by using the Initialize GPS command. This makes your unit think
it's located at the position you select. See its entry following the en-
try for
Hide GPS Features.
Initialize GPS
This command is handy when you are practicing in simulator mode.
(See the entry in this section for
(See the entry in this section for
GPS Simulator.) In simulator mode,
this command makes the IntelliMap 320 operate as if it sitting some-
place other than its actual location. So, you and your unit could be lo-
cated in Kansas City, but easily practice navigating in the ocean off Is-
lamorada, Florida.
place other than its actual location. So, you and your unit could be lo-
cated in Kansas City, but easily practice navigating in the ocean off Is-
lamorada, Florida.