HP Compaq KB-9965 311059-231 ユーザーズマニュアル

Configuring the server’s memory system requires configuring both hardware and software.  

To configure the memory: 

1.  Remove the memory board. Refer to “Removing a Memory Board” in this chapter. 

2.  Install the required DIMMs based on the desired memory configuration. Be sure to 

follow all DIMM installation requirements. Refer to the “DIMM Installation 
Requirements” section in this chapter for each mode. 

3.  Install the memory board. Refer to “Installing a Memory Board” in this chapter. 

4.  Test the DIMMs: 

a.  Power on the server. 

b. Press 

the 

F9 key to enter RBSU. 

c. Select 

Advanced Options. 

d. Change 

POST Speed Up to disable. 

e.  Press any key to return to the RBSU main menu. 

f. Select 

System Options. 

g. Select 

Advanced Memory Protection. 

h.  Select the desired memory mode. 

i. Press 

the 

Esc key twice to go back to the main RBSU menu. 

j. Press 

the 

F10 key to exit RBSU. The server reboots and tests all memory in the 

system. 

k.  Once the memory has been tested, change POST Speed Up to enable for faster 

system boot, if desired. 

 

  To reconfigure the memory mode after initial setup, you must reboot the system and 

enter RBSU.