Echo u-handle srm-280s ユーザーズマニュアル

Level 1.

Tools Required:   8 & 13mm Open End Wrenches, Screwdriver, Clean   

 

 

 

Rag, Grease Gun

Parts Required:   POWER BLENDX

TM

 8 oz. (P/N 91014) or Lithium    

 

 

 

Base Grease.

1.  Clean all loose debris from gear box.

2.  Remove plug (A) and check level of grease. Grease should fill gear 

case to bottom of grease plug hole.

3.  Add grease if necessary using manual grease gun or squeeze-type 

tube. Do not use high pressure grease gun. DO NOT over-fill.

1.  Loosen two (2) screws (B) and remove center locating screw (C).   

Pull gear box and shield from drive shaft housing.

2.  Pull flexible cable from the drive shaft housing, wipe clean and  

re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3.  Slide the flexible cable back in the drive housing.  DO NOT get  

dirt on the flex cable.

4.  Install the gear housing and shield assembly.

Flat edge of washers (D) must be against drive shaft.

No Lubrication Needed.