Echo SRM-210i ユーザーズマニュアル

1. Align hole in upper plate with notch in edge of gear housing and

insert head locking tool (C).

2. Be sure upper plate (A) remains on PTO shaft.

3. Place line head onto PTO shaft. Followed by large metal washer.

4. Thread L.H. nut on PTO shaft. Tighten securely.

5. Install new split pin.

6. Remove locking tool (C).

1. Shut engine off. Lay unit on the ground with head assembly up.

2. Remove old nylon line through center recess of head.

3. Thread new lines through outside holes (D) in housing until ends

meet in center of recess.

NOTE
Insert cutting line ends to center of head recess to insure easy
removal of used lines.

1.

Position front handle for comfortable operation and secure screws.