Electrolux 137098000 ユーザーズマニュアル

       WARNING

ELECTRICAL SHOCK HAZARD

Failure to disconnect power source before servicing 
could result in personal injury or even death.  

B) Removing Door from Hinge

  1  Reopen door to 90 degree angle.
  2  Remove 4 long, course-thread, counter-sunk 

hinge screws from door. 

A) Removing Trim Ring

  1  Open the door to a 90 degree angle.
  2  Remove and save the trim plug and long, 

course-thread, panhead screw. 

  3  Close the door.
  4  Rotate the door trim approximately ¾” 

counter-clockwise and pull it away from the 
front of the door.

  3  While supporting the weight of the door 

with both hands, separate the door from the 
hinge.

 4  Gently place the door face down on a flat,

covered work surface. 

Reversing Door

  1  Be sure you have adequate swing area before reversing door.
  2  You will need a screw driver with a #2 square bit.
  3  Protect flat work surface, such as top of washer or floor near 

washer, with a soft cloth or towel.

  4  Be sure washer is unplugged from power source!

Screwdrivers with

#2 square &

straight bit