Electrolux 137067200 ユーザーズマニュアル

CIRCUIT -  Individual, properly polarized and 

grounded 15 amp. branch circuit fused with 15 
amp. time delay fuse or circuit breaker.

POWER SUPPLY - 2 wire, with ground, 120 volt

single phase, 60 Hz, Alternating Current.

OUTLET RECEPTACLE - Properly grounded

3-prong receptacle to be located so the power 
supply cord is accessible when the washer is in 
an installed position.

Grounding type

wall receptacle

Power cord with

3-prong  grounded plug

Installation Requirements

       NOTE

Because of potentially inconsistent voltage 
capabilities, the use of this washer with power 
created by gas powered generators, solar 
powered generators, wind powered generators 
or any other generator other than the local utility 
company is not recommended.

       NOTE

Drain hose attached to the washer can reach a 79
in. (201 cm) high standpipe. For higher standpipe,  
use hose P/N 137098000, available from an 
authorized parts distributor. 

       NOTE

GFI (Ground Fault Interrupter) receptacle is not
required.

       WARNING

ELECTRICAL SHOCK HAZARD

Improper connection of the equipment grounding 
conductor can result in a risk of electrical shock. 
Check with a licensed electrician if you are in 
doubt as to whether the appliance is properly 
grounded.

The washer MUST be grounded. In the event 

1. 

of malfunction or breakdown, grounding will 
reduce the risk of electrical shock by a path of 
least resistance for electrical current.
Since your washer is equipped with a power 

2. 

supply cord having an equipment-grounding 
conductor and a grounding plug, the plug 
MUST be plugged into an appropriate, copper 
wired receptacle that is properly installed and 
grounded in accordance with all local codes and 
ordinances or in the absence of local codes, 
with the National Electrical Codes, ANSI/NFPA 
70 (latest edition). If in doubt, call a licensed 
electrician. DO NOT cut off or alter the grounding
prong on the power supply cord. In situations 
where a two-slot receptacle is present, it is 
the owner’s responsibility to have a licensed 
electrician replace it with a properly grounded 
three prong grounding type receptacle.

Hot and cold water faucets MUST be installed 
within 42 inches (107 cm) of your washer’s water 
inlet. The faucets MUST be 3/4 inch (1.9 cm) with 
threading for laundry hose connection. Water pres-
sure MUST be between 30 and 120 psi. Pressure 
difference between hot and cold cannot be more 
than 10 psi. Your water department can advise you 
of your water pressure.

Drain capable of eliminating 17 gals (64.3 L) per

1. 

minute.
A standpipe diameter of 1-1/4 in. (3.18 cm) 

2. 

minimum. 
The standpipe height above the floor should be: 

3. 

Minimum height:   24 in. (61 cm) 
Maximum height:  96 in. (244 cm)