Sharp AR-157E ユーザーズマニュアル
31
6
STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the relevant page.
alphanumeric codes appear in the display, solve the problem immediately referring
to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication
Cause and remedy
Page
Developer
replacement
required indicator
replacement
required indicator
Steadily
lit
lit
Developer is required. Contact your SHARP
service center as soon as possible.
service center as soon as possible.
37
Toner cartridge
replacement
required indicator
replacement
required indicator
Steadily
lit
lit
Replacement of toner cartridge will be needed
soon. Prepare a new cartridge.
soon. Prepare a new cartridge.
25
Blinking
Toner cartridge must be replaced. Replace it
with a new one.
with a new one.
25
Misfeed indicator
Blinking
A misfeed has occurred. Remove the misfed
paper referring to the description of "MISFEED
REMOVAL".
paper referring to the description of "MISFEED
REMOVAL".
32
The lower side cover may be open. If so, close it.
35
Maintenance
indicator
indicator
Steadily
lit
lit
Service by an authorized SHARP service
technician is required.
technician is required.
37
RSPF/SPF misfeed
indicator
indicator
Blinking
An original misfeed has occurred in the RSPF/
SPF. Remove the misfed originals referring to
the description of "E: Misfeed in the RSPF/SPF".
SPF. Remove the misfed originals referring to
the description of "E: Misfeed in the RSPF/SPF".
35
Power save indicator is
steadily lit.
steadily lit.
The unit is in the preheat mode. Press any key to
cancel the preheat mode.
cancel the preheat mode.
22
The unit is in the auto power shut-off mode.
Press the start (
Press the start (
) key to cancel the auto power
shut-off mode.
22
The paper tray indicator is
blinking.
blinking.
The paper tray is not installed properly. Push the
tray into the unit securely.
tray into the unit securely.
8
"CH" is blinking in the
display.
display.
A toner cartridge is not installed. Installed a toner
cartridge. If "CH" is blinking even if a cartridge is
installed properly, contact SHARP service
center.
cartridge. If "CH" is blinking even if a cartridge is
installed properly, contact SHARP service
center.
25
"CH" is steadily lit in the
display.
display.
Side cover is open. Close the side cover
securely by pressing the round projections near
the side cover open button.
securely by pressing the round projections near
the side cover open button.
–
"P" is blinking in the display.
The paper tray or multi-bypass tray is empty.
Load paper.
Load paper.
8, 10
A misfeed has occurred in the paper tray, multi-
bypass tray. Remove the misfed paper.
bypass tray. Remove the misfed paper.
32
A letter and a number appear
alternately.
alternately.
The unit will not function. Turn the power switch
off, remove the power cord from the outlet, and
contact your SHARP service center.
off, remove the power cord from the outlet, and
contact your SHARP service center.
–