Eureka 2500 ユーザーズマニュアル

17

1.

Remove the screws from each side
of the suction cover.

2.

Lift the suction cover off and clean
the area of dirt and lint.

3.

Replace the suction cover by sliding
the tabs on top of the suction cover
into the top slots on the hood. Make
sure the suction cover gasket is in
place on the unit before replacing
cover.

4.

Align one of the screw holes in the
suction cover, hood and base then
secure with screw. Also complete
this step for second screw hole.

1.

Remove the clean water solution tank.

2.

Remove the Plunger, Boot Seal and Filter
Assembly by lifting up the Boot Seal. This will
pull out the Plunger, Boot Seal and Filter
Assembly (see Figure 1).

3.

Remove the Reservoir Filter and clean it by
removing any debris and rinsing with water.

4.

Reinsert the Filter on the Plunger stem and
place the Assembly directly into the reservoir.
Install this assembly into the reservoir by
pressing down on the top of the plastic plunger.
Do not press down on the rubber boot seal.

IMPORTANT! Make sure the plunger stem

is placed into the hole in the
bottom of the reservoir for a
secure fit (see Figure 2).

5.

Replace the Clean Water Solution Tank back
onto the carpet shampooer/extractor unit.

Suction Cover Gasket
(around rim of suction
cover area on unit)