Trimble Outdoors r7 ユーザーズマニュアル

Trimble R7/R8 GPS Receiver User Guide     1 4 7

Software Utilities     1 6

4.

Select Rover radio, then from the Type field select Trimble 
Internal.

5.

Tap the 

!

 softkey.

6.

Once connected, in the Network number field enter the number 
of the network set on your base radio.

7.

Tap the 

E

 softkey to complete configuration.

To configure the radio network using WinFlash:

1.

Connect the data/power cable to Port 1 on the receiver.

2.

Connect the female DE-9 connector on the other end of the 
data/power cable to a serial (COM) port on the computer.

3.

Start WinFlash. The Device Configuration dialog appears.

4.

From the Device type list, select Trimble R8 Receiver.

5.

From the PC serial port field, select the serial port on the 
computer that the receiver is connected to and click 

.

6.

From the Operation selection dialog, select Configure radio and 
click 

.

7.

Confirm that your current settings are correct and click 

. 

The Configure 900MHz radio dialog appears.

8.

In the Network number field, select the same network that is set 
on your base radio.

9.

In the Country setting field, select one of the following 
(according to how your base radio was shipped):

–

Your country (if available). This sets the radio to the a 
specific frequency range being transmitted by the base 
radio.

–

A single frequency. This limits the frequencies used to 
those authorized in your particular country.

10. Click 

.

WinFlash updates the radio settings and then restarts the receiver.