Sharp AR-BC320 ユーザーズマニュアル

ページ / 140
NORMAL COPYING
5-6
Automatic two-sided copying from the reversing automatic
document feeder
When a duplex module/2 x 500 sheet paper drawer and a duplex bypass/inverter unit are installed, the following
automatic two-sided copy functions are possible. The copy paper is turned over automatically, allowing easy two-
sided copying.
The following two-sided modes can be selected
1.  Automatic two-sided copying from one-sided
originals
2.  Automatic two-sided copying from two-sided
originals
3.  Automatic one-sided copying from two-sided
originals
● This function can be used even if a duplex module/2 x
500 sheet paper drawer and/or a duplex bypass/
inverter unit are not installed.
1
Place the originals in the document feeder
tray. (pages 4-6 t
o 4-9)
2
Touch the [2-SIDED COPY] key.
3
Select the desired duplex copy mode.
The left screen shows
the display when a
reversing automatic
document feeder, a
duplex module/2 x 500
sheet paper drawer, and
a duplex bypass/inverter
unit are installed. The display will vary depending
on the equipment installed.
If a copy key is touched for a mode that cannot be
selected, a double beep will be sounded.
The image to be copied onto the second side of 2-
sided copies can be inverted so that the resultant
2-sided copies are in the correct orientation for
binding at the top. For top binding, touch the
[BINDING CHANGE] key on the 2-sided copy
selection screen.
4
Touch the [OK] key.
Make selections and proceed as in steps 6 to 9 on
pages 5-2 and 5-3.
NOTE
Certain restrictions exist depending on the amount of memory installed and the copy settings. (See "Copy mode
output restrictions
" and "Guidelines for the number of scannable originals during sort copying" on page 5-4.)
Original
Copy
2-SIDED COPY
OUTPUT
SIDED COPY
BINDING
CHANGE
READY TO COPY.
INTERRUPT
OK
Example of a 
portrait-oriented 
original
Example of a 
landscape-oriented 
original
BINDING
CHANGE
OK
WhaleII_general-copy_SEC.book  6 ページ  2004年9月14日 火曜日 午前11時45分