Spin Master air hogs room raider ユーザーズマニュアル

Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master, Inc., PMB #10053, 300 International Drive, Suite 100, 
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F, 
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK

North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com

TM and © 2006 Spin Master Ltd. Air Hogs ® is a registered 
trademark of Spin Master Ltd. All rights reserved. Conforms to
product safety standards ASTM F963-03, EN71 regulatory 
requirements. Products and colors may vary. Please retain this
information for future reference. Patent Pending. 
MADE IN CHINA.

Item #44210

44210-ENG-IS-2 

#20004655, #20004658   REV 2    US English

1. Open door on the controller to access

the charge cable.

2. Plug charge cable into the charge port.

3. Slide the power switch on the controller

to “CHARGE”. The charge light will flash
while charging and stop flashing when
the battery is fully charged.

4. Remove the charge cable from the

charge port, store it in the charger and
close the storage door.

NOTE: For best flight performance, 
fully charge your Room Raider

TM

before

each flight.

Room Raider

TM

will not start or
has lost power.

Room Raider

TM

is flying too low.

1. You have not set the motor switch to “ON”.
2. Battery power is low.
3. Batteries (+) or (-) are not correctly placed

inside the battery compartment.

4. Room Raider

TM

battery is low.

5. Safety auto-cutoff is activated.

1. Needs more power.
2. The batteries in the controller are drained.
3. Room Raider

TM

battery is low.

1. Push motor switch to “ON”.
2. Replace the controller batteries.
3. Be sure to align the (+) and (-) polarities with the 

corresponding markings inside the battery compartment.

4. Recharge Room Raider

TM

.

5. Turn jet off, wait 3 seconds then turn back on.

1. Squeeze the throttle trigger more.
2. Install new batteries.
3. Recharge Room Raider

TM

.

1. Turn the jet “ON/OFF” switch to “ON”.

2. Turn the controller “ON”.

3. Hold the controller in one hand and jet 

as shown.

4. Squeeze the throttle trigger about 1/2

way and gently toss the Room Raider

TM

into the air. The Room Raider

TM

will begin

flying in circles to the left.

5. Control the altitude by squeezing the

throttle trigger.

Charge

Cable

Do not

hold here

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for its compliance could void the user’s 
authority to operate the equipment.