Sharp AR-168D ユーザーズマニュアル
MAKING COPIES
21
3
Using the SPF/RSPF
1
Make sure that an original has not been left on the document
glass.
glass.
2
Adjust the original guides to the size
of the originals.
of the originals.
3
Set the original(s) face up in the
document feeder tray.
document feeder tray.
The SPF/RSPF indicator on the operation
panel will light up. If this indicator does not
light up, the originals are not properly set or
the SPF/RSPF is not properly closed.
panel will light up. If this indicator does not
light up, the originals are not properly set or
the SPF/RSPF is not properly closed.
4
Select the number of copies and other copy settings, and then
press the [START] key (
press the [START] key (
).
• Originals that are 5-1/2" x 8-1/2" to 8-1/2" x 14" and 14 lbs. to 24 lbs.
(52 g/m
2
to 90 g/m
2
) can be used. A maximum of 30 pages can be
placed at once.
• Straighten curled originals before placing them in the document
feeder tray. Curled originals may cause misfeeds.
• Place originals horizontally.
• Before placing originals in the document feeder tray, be sure to
• Before placing originals in the document feeder tray, be sure to
remove any staples or paper clips from them.
• When a copy is made, the edges will not be copied (
image loss
).
For the image loss, see the "SPECIFICATIONS" (p.92).
• When using the margin shift function, check the position of the
margins carefully. (p.34)
• To stop copying in the middle of a run, press the [CLEAR] key (
).
• For the copy settings, see pages 23 through 35.
Note
Original face up
Note