Alienware M18X ユーザーズマニュアル

ページ / 72
41
CHAPTER 4: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS 
Upgrading or Replacing Memory
Your laptop is equipped with a configurable memory unit. The industry standard 
JEDEC  PC3-12800  (DDR3-1600)  SODIMM  memory  module  connectors  are 
available for memory upgrade.  
NOTE: If you purchased a dual‑core processor, your computer supports 
only memory module connectors DIMM A and DIMM B.
NOTE: The table below illustrates one possible way the system memory 
can be configured. You can also configure the system memory by 
installing memory modules in connectors DIMM C and DIMM D.
Memory 
connector  
DIMM A
Memory 
connector 
DIMM B
Memory 
connector 
DIMM C
Memory 
connector 
DIMM D
Total 
memory
2 GB
2 GB
4 GB
2 GB
4 GB
6 GB
4 GB
4 GB
8 GB
8 GB
8 GB
16 GB
8 GB
8 GB
8 GB
8 GB
32 GB
Removing the Memory Module(s)
NOTE: Your computer supports up to four memory module connectors. 
You can access connectors DIMM A and DIMM B by removing the 
compartment door at the bottom of your computer. To upgrade memory 
module(s) in connectors DIMM C and DIMM D, see the Service Manual at 
support.dell.com/manuals. 
Follow the instructions in “Before You Begin” on page 
1. 
Remove the battery (see “Replacing the Battery Pack” on page 
2. 
40).
Remove the four screws that secure the compartment door to the 
3. 
computer base.
Slide the compartment door towards the rear of the computer, lift it up, 
4. 
and then remove it from the computer.