Sharp r-3a88 ユーザーズマニュアル

23

After any service, make sure of the following :
1. Door latch heads smoothly catch latch hook through

latch holes and that latch head goes through center of
latch hole.

2. Deviation of door alignment from horizontal line of cavity

face plate is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity

face plate.

4. Check for microwave leakage around door with an

approved microwave survey meter.  (Refer to Microwave
Measurement Procedure.)

Note:

The door on a microwave oven is designed to act as
an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be air-
tight, moisture (condensation)-tight or light-tight.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around
oven door is not abnormal and do not of themselves,
indicate a leakage of microwave energy from oven
cavity.

UPPER 
OVEN HINGE

PIN

DDOR PANEL

CHOKE 
COVER

PIN

LOWER 
OVEN 
HINGE

Installation
1. Put the adhesive tape on the backing film of the sealer

film as shown in Fig. C-8.

2. Tear the backing film by pulling the adhesive tape.
3. Put the pasted side of the sealer film on the door panel

Sealer film

Backing film

Adhesive tape