Zebra 50-12500-066 ユーザーズマニュアル

6 - 2

LI4278 Product Reference Guide

The linear imager scanner must be connected to the cradle for the host parameter setting to take effect. When 
the linear imager scanner is not connected to a cradle, and a host parameter bar code is scanned, a long 
low/long high beep sequence sounds.

To connect the Keyboard Wedge interface Y-cable:

Turn off the host and unplug the keyboard connector.

Attach the modular connector of the Y-cable to the host port on the bottom of the linear imager scanner 
cradle (see 

).

Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.

Connect the round female DIN keyboard connector of the Y-cable to the keyboard connector.

If needed, attach the optional power supply to the connector in the middle of the Y-cable.

Ensure that all connections are secure.

Turn on the host system.

Select the Keyboard Wedge host type by scanning the appropriate bar code from 

.

To modify any other parameter options, scan the appropriate bar codes in this chapter.

If a power supply is used, disconnect the power supply before changing host cables or the cradle may not 
recognize the new host.

See 

 for information about linear imager scanner/cradle pairing 

and wireless communication.

Male DIN 
Connector

Female DIN
Keyboard Connector

Keyboard 

Connector

Y-cable

Interface cables vary depending on configuration. The connectors illustrated in 

 are examples only. 

The connectors may be different than those illustrated, but the steps to connect the cradle remain the same.