Aleratec 330107 ユーザーズマニュアル

www.aleratec.com

12

4.  When Compare is complete the display will show the total, and the 

number that pass and fail. 

Asynchronous Compare is used only when the source content is the same as 

or less than the system buffer (256MB). With the source content read into 

the systems buffer you can compare flash drives continuously by taking out 

the drive which has finished comparing, and replacing it with another flash 

drive. This process is repeated until the comparison job is complete.    

1.  Load the source flash drive into the USB Duplicator. Use the UP or 

DOWN arrow to scroll through the menu until Compare is displayed 

on the LCD screen.  

2.  Press the OK button on the display panel. The USB Duplicator will 

start to read the source content into the system’s buffer and immediately 

start comparing any loaded target USB flash drives.

3.  Load the target flash drives to be compared into the USB Duplicator. 

The LCD will display the number of flash drives loaded and comparing.

Note: When compare is in process the Green LED on the front panel 
is blinking. Do not take out the drive while it is comparing. When 
comparing is finished the Green LED stays on (no blinking). If an error 
occurs during the process a Red LED will display. 































