Ampro Corporation dlp 5200 ユーザーズマニュアル

 

Turn the keyboard over onto its face.

 

By pressing the two latch tabs simultaneously, pry open the battery door with your
fingers.

 

Insert 4 AA alkaline batteries with the positive (+) and negative (-) orientation as shown
inside the compartment (negative is at the flat end of the battery and goes towards the
spring).

 

Replace the batteries door and make sure both latch tabs snap into place.

 

Turn the projector off.

 

Open the front access panel.

 

Locate the mouse and keyboard ports.

Mouse Connection

 

Identify the mouse connector of the “Y” adapter.

 

Connect the 6-pin round din connector to the mouse port on the projector

Keyboard Connection

 

Identify the keyboard connector of the “Y” adapter. The one marked with a
keyboard symbol.

 

Plug the connector into the port-labeled keyboard on your projector.

One all connections are made (IR Remote and Keyboard), power the projector on.

The keyboard and mouse cables on the receiver have very similar connections. Take care not to mix
them up. No damage will result, but your keyboard and mouse pad will not work properly.

Mouse Pad Connector

Keyboard / Mouse Pad
IR Receiver

Keyboard Connector

“AT” Keyboard Adapter

PS/2 Mouse Port

Keyboard Port