American Dynamics speeddome ultra outdoor housing adsduhos ユーザーズマニュアル

-

 This housing meets IP66/Nema 4 ratings 

provided it is used with a properly installed ROENDC End 
Cap Assembly and one of the following mounts: RHOTR 
Over-the-Roof Mount, RHOSW Short Wall Mount, or 
RHOLW Long Wall Mount. 

At end of pipe. 

Ensure black foam plug is around 
cable and press-fit into pipe. 

Ensure seal and sleeve are 
properly set. 

See A, B, C. 

Line up. 

Push to line and 

maintain 

compression. 

Tighten. 

Thread cables through end 
cap assembly and attach 
housing to mounting 
structure. 

Keep cables from 
twisting while turning 
housing. 

Turn until no threads 
are exposed. 

Attach cable 
connectors. 

Make connections, 
insert cables into end 
cap assembly, and 
attach cover. 

Check o-ring is 
properly set. 

Page 1 of 12       8200-0492-02, Rev. C

Seal 

Sleeve 

Pin 1 - Black (24Vac) 
Pin 2 - Red (Common) 
Pin 3 - White (24Vac) 

Pin 1 - + (video high) 
Pin 2 - – (video ground)

Pin 1 - Blue (NC)* 
Pin 2 - Purple (Common)* 
Pin 3 - Gray (NO)* 
Pin 4 - White/Red (Alarm Return) 
Pin 5 - White/Black (Alarm 1) 
* Relay contact not to exceed 1A @ 

30Vdc or 0.3A @ 125Vac.

Pin 1-4 - Not used 
Pin 5 - White/Orange (Manchester W) 
Pin 6 - White/Yellow (Manchester B)

Pin 1 – Orange (Rx +) 
Pin 2 – Green (Rx –) 
Pin 3 – Yellow (Tx +) 
Pin 4 – Brown (Tx –) 
Pins 5-6 - Not used 

Pin 1-4 - Not used 
Pin 5 - White/Orange (SensorNet Hi) 
Pin 6 - White/Yellow (SensorNet Lo)

Pin 1 - White/Blue (Alarm 2) 
Pin 2 - White/Brown (Alarm 3) 
Pin 3 - White/Purple (Alarm 4) 
Pin 4 - White/Red (Alarm Return)