Advantech som-4450 cpu system on module som-4450 etx ユーザーズマニュアル

Chapter 3  Software Configuration

1. Apply power to the SOM-4450 application with a color TFT display

attached. This is the default setting for the SOM-4450 series. Make
sure that the AWDFLASH.EXE and *.BIN files are located in the
working drive.

Note:

Make sure that you do not run AWDFLASH.EXE
while your system is operating in EMM386 mode.

2. At the prompt, type AWDFLASH.EXE and press <Enter>. The

VGA configuration program will then display the following:

3. At the prompt, type in the BIN file which supports your display.

When you are sure that you have entered the file name correctly
press <Enter>. The screen will ask “Do you want to save?” If you
wish to continue press Y. If you change your mind or have made a
mistake press N.

4. If you decide to continue, the screen will issue a prompt which will

then ask “Are you sure to program (Y/N)?” If you wish to continue,
press Y. Press N to exit the program.

The new VGA configuration will then write to the ROM BIOS chip.
This configuration will remain the same until you run the
AWDFLASH.EXE program and change the settings.