Epson expression 1680 ユーザーズマニュアル
58
Requirements and Notices
Macintosh
■
Macintosh OS 8.6 to 9.x, or OS 10.1.2 to 10.2.x
Note: Check the Apple
®
web site for any updates to your operating system.
■
Macintosh standard (built-in) SCSI or compatible PCI SCSI/SCSI 2 card, or USB interface; for
IEEE 1394 FireWire connections, either a built-in IEEE 1394 FireWire port or an IEEE 1394
FireWire PCI card (FireWire card must be OHCI-compliant)
IEEE 1394 FireWire connections, either a built-in IEEE 1394 FireWire port or an IEEE 1394
FireWire PCI card (FireWire card must be OHCI-compliant)
■
128MB RAM (256MB RAM recommended)
■
300MB available hard disk space
■
CD-ROM drive
■
VGA color monitor with 640 × 480 screen resolution (a color monitor with a resolution of
800 × 600 or higher recommended)
800 × 600 or higher recommended)
■
16-bit 65K-color display adapter card (24-bit display adapter card with millions of colors
recommended)
recommended)
Important Safety Instructions
Read all of these instructions and save them for later reference. Follow all warnings and instructions
marked on the scanner.
marked on the scanner.
■
Unplug the scanner before cleaning. Clean with a damp cloth only. Don’t spill liquid on the
scanner. Use a soft, dry cloth or a compressed air spray designed for cleaning electronic equipment
to clean dust from the document table glass.
scanner. Use a soft, dry cloth or a compressed air spray designed for cleaning electronic equipment
to clean dust from the document table glass.
■
Do not place the scanner on an unstable surface or near a radiator or heat source.
■
Use only the type of power source indicated on the scanner’s label.
■
Connect all equipment to properly grounded power outlets. Avoid using outlets on the same
circuit as photocopiers or air control systems that regularly switch on and off.
circuit as photocopiers or air control systems that regularly switch on and off.
■
Do not let the power cord become damaged or frayed.
■
If you use an extension cord, make sure the total ampere rating of the devices plugged into the
extension cord doesn’t exceed the cord’s ampere rating. Also, make sure the total ampere rating of
all devices plugged into the wall outlet doesn’t exceed the wall outlet’s ampere rating.
extension cord doesn’t exceed the cord’s ampere rating. Also, make sure the total ampere rating of
all devices plugged into the wall outlet doesn’t exceed the wall outlet’s ampere rating.
■
Do not attempt to service the scanner yourself.
■
Unplug the scanner and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the scanner; if the scanner
has been dropped or the cabinet damaged; if the scanner does not operate normally or exhibits a
distinct change in performance. Do not adjust controls that are not covered by the operating
instructions.
conditions: if the power cord or plug is damaged; if liquid has entered the scanner; if the scanner
has been dropped or the cabinet damaged; if the scanner does not operate normally or exhibits a
distinct change in performance. Do not adjust controls that are not covered by the operating
instructions.
1680.book Page 58 Wednesday, April 9, 2003 4:09 PM