Tascam 302mkII ユーザーズマニュアル

Unless you use multiple 302MkII units connected in
series, set the OFF/SLV/MSTR switch to the left OFF
position all the time. 

1. Check to see that the source is connected to the

DECK 1 INPUT connectors if you intend to record
on deck 1 only or on deck 1 and deck 2 simul-
taneously. Use the DECK 2 INPUT connectors if
you intend to record on deck 2 only. 

2. Press 

 to turn on the unit. 

3. Press either or both 

 buttons to open the

cassette compartments, insert cassettes, and close
the compartments.

4. Press either or both 

 buttons so you can use

the RTZ (return-to-zero) function to locate the
record start point.

5. Make the following switch settings : 

 switch to Ä if you intend to record

on one side of the tape(s) only or ä to record on
both sides continuously ; 

 switch to 

 ; 

 switch to the desired position. 

6. If you intend to record on both deck 1 and deck 2

simultaneously, press the 

 button. Its

LED will turn on and both decks will go into
Record Ready mode. 

If you are using only one of the two decks, put it
i n t o   R e c o r d   R e a d y   m o d e   b y   h o l d i n g   d ow n

 and pressing 

. 

7. Start the external source and adjust the 

control(s) so that the meter reading is around 0 dB.
Use the 

 control(s) to balance the left and

right input levels. 

8. To start recording, press 

 on the deck in use. If

DUAL REC is activated, you can press PLAY on
either deck to start recording on both decks. 

To stop recording, press 

. If DUAL REC is

activated, you can press STOP on either deck to
stop both tapes. The DUAL REC LED will then
turn off. 

To audition the recording just completed, press

, then press 

 for the deck whose LED is

blinking.

You can record a 4-second silence by

holding down 

 and pressing 

 (or by

pressing the optional remote 

 button) after

p r o g r a m   m a t e r i a l   a s   b e e n   r e c o r d e d .  T h e   C P S
(Computer-controlled Program Search) function
(discussed below) identifies specific programs by
counting a blank space of 4 seconds or more between
programs.