Shark euro-pro x gi468 ユーザーズマニュアル

Always read garment labels and follow 
the manufacturer’s ironing instructions. 
Refer to the “Ironing Chart” on page 9 
for temperature recommendations:

•  Use low settings for nylon and other 

synthetics.

••  Use moderate settings for wool, 

silks, and blends.

•••  Use high settings for cottons and 

linens.

1.  Stand the iron upright on its heel.
2.  Plug the cord into a polarized, 120V 

AC electrical outlet.

3.  Press the electronic temperature 

control until you get the desired 
fabric/temperature setting.

4.  The light on the right side of the LED 

display panel will stop flashing when 
the desired temperature has been 
reached. (Fig. 5)

• 

Sort articles to be ironed according 
to the type of fabric. This will reduce 
the need to adjust the temperature 
for different types of garments.

• 

If you are not sure of the fiber 
content of a garment, test fabric by 
ironing a small area such as a seam 
or inside hem section before ironing 
a visible area. Start with a low 
temperature setting and gradually 
increase to find the best setting.

• 

When reducing the temperature to 
iron sensitive fabrics, allow 
approximately 2 minutes for the iron 
to cool to the new temperature 
setting.

• 

Fabrics such as velour, wool, linen 
and silk are best ironed with an 
ironing cloth to prevent shine marks.

4.  Place the iron on its heel on a stable, 

protected surface and allow the iron 
to heat for approximately two (2) 
minutes or until the temperature 
settings on the right side of the LED 
display panel have stopped flashing.

5.  Turn the variable steam control dial 

to the right to increase the amount of 
steam. When using extra steam, the 
iron uses more water and it may be 
necessary to fill the water tank more 
often. (Fig. 2)

The burst of steam position is useful 
when ironing denim, cotton and linens. It 
provides quick bursts of steam which 
aid in removing stubborn wrinkles.

The burst of steam feature can be used 
with Dry or Steam ironing as desired.
1.  Make sure the water tank is at least 

1/2 filled with water.

2.  Select the desired fabric and 

temperature setting. Place the iron 
on its heel (on a stable, protected 
surface) and allow it to heat for 
approximately 2 minutes.

3.  Position variable steam control to the 

burst of steam position. (Fig. 3)

4.  With the iron in a horizontal position, 

press the steam button several times 
to prime the pump. 

5. 

Slide the variable steam control 
up to increase the amount of 
steam. (Fig. 3) When using extra 
steam, the iron uses more water 
and it may be necessary to fill 
the tank more often. See page 4 
for refilling the iron with water.

6. 

Steam is produced as soon as 
the iron is held in the horizontal 
position. Steam will stop coming 
out when the iron is put on its 
heel in a vertical position or by 
setting the variable steam control 
to “0”.

The atomizer spray nozzle is useful on 
fabrics with stubborn wrinkles. Press the 
spray button and a jet of water will spray 
onto the fabric being ironed. (Fig. 4) The 
water spray can be used with dry or 
steam ironing as desired.