Adam Equipment mdw-160m ユーザーズマニュアル

© Adam Equipment Company 2006 

 

 

7

•  The measuring arm should be held horizontal and above the 

person’s head and should not be released. 

 

• Carefully lower the measuring arm, while keeping it 

horizontal, until it rests gently upon the top of the person’s 
head

.  

If the person is shorter than 101.5 cm, push the latch 

to the right, while simultaneously pushing down the 
measuring arm until it rests horizontally upon the top of the 
person’s head. 

 

 

Read the height of the person as follows: 
 

•  The rear end of the measuring arm is tapered to point at the 

reading on the height rods. 

 

•  If the tapered end of the measuring arm points at the outer 

height rod, then the height of the person is same as the 
reading at this point on the outer height rod. 

 

•  If the tapered end of the measuring arm points at the inner 

height rod, then the correct height of the person is same as 
the reading shown on the inner height rod where both the 
height rod meets, i.e.,  read at the top of the outer height rod 
(Just above the “Read” arrow marked on the outer height 
rod). 

 

•  While holding the measuring arm horizontally, raise the arm 

above the person’s head.  The person may now step off the 
scale platform.  Hold the arm horizontal until the person is 
clear of the height rod. 

 

•  Fold the measuring arm back to the vertical position and 

adjust the height rod back to the rest position (i.e. the 
measuring arm should be locked in place within the inner 
height rod and the inner rod should be at its lowest position).