Electrolux LS14 ユーザーズマニュアル

15

system save up to 30% in time over traditional models. 
If the hood is opened during this stage the message 
"CLOSE" will scroll on the display:

The filling and heating stage has finished when the 
display shows the tank temperature:

To display the boiler temperature during heating of the 
tank, open the hood and press “J” button (Figure 13).

The wash cycle includes one wash with hot water and 
detergent (150°F/66°C min.) and one rinse with hot 
water and rinse-aid (180°F/82°C min.).

Standard cycle time with supply water at 122°F/50°C.

A device lengthens the cycle time if the water in the boi-
ler has not reached the minimum temperature for correct 
rinsing.

The cycle times and the temperature may be personali-
sed (e.g. increase of the rinse time and temperature).

The cycle times should only be set by an Authorized 
Service technician.

The filling and heating stage has finished when the dis-
play shows the tank temperature:

The appliance is then ready for use:

•

Raise the hood.

•

Pour the required amount of detergent into the tank 
(in models without automatic dispenser).

•

Insert the rack containing the dirty dishes.

Close the hood and select the suitable wash cycle; the 
corresponding indicator light comes on and the wash 
cycle starts:

- Cycle I

For lightly soiled dishes: press “J” button (Figure 13) 
(see table of times).

- Cycle II (recommended)

For normally dirty dishes: press “H” button (Figure 13) 
(see table of times).

For very dirty dishes: press “F” button (Figure 13) 
(see table of times).

For particularly dirty dishes with dried food residue, 
dishes with a special shape or for other specific needs of 
the user: press “G” button (Figure 13), which initiates a 
continuous wash until the operator selects an automatic 
cycle.

•

To stop the wash cycle, just press the selected cycle 
button or open the hood.

•

To continue the wash cycle, just press the selected 
cycle button or close the hood. The cycle starts again 
from where it stopped.

•

At the end of the wash, the dishwasher emits a series 
of beeps and “END” blinks on the display:

lift the hood and remove the rack containing the clean 
dishes.

60 sec.

70 sec.

120 sec.

INFINITE