Smeg lavatrice lbs128f ユーザーズマニュアル

11 - EN

6 Solution suggestions for problems

Cause

Explanation / Suggestion

Program cannot be started or selected.

•  Machine may have switched to self protection

mode due to an infrastructure problem (such

as line voltage, water pressure, etc.).

•  Reset your machine by pressing “Start/Pause/

Cancel” button for 3 seconds. (see, Canceling a

Program)

There is water coming from the bottom of the machine.

•  There might be problems with hoses or the

pump filter.

•  Be sure the seals of the water inlet hoses are

securely fitted.

•  Tightly attach the drain hose to the tap.

•  Make sure that the pump filter is completely

closed.

Machine stopped shortly after the program started.
•  Machine can stop temporarily due to low

voltage.

•  It will resume operating when the voltage is back

to the normal level.

It continuously spins. Remaining time does not count down. (For models with a display)

•  There may be an imbalance of laundry in the

machine.

•  The automatic spin correction system might have

been activated due to the unbalanced distribution

of the laundry in the drum.

•  The laundry in the drum may be clustered

(bundled laundry in a bag). Laundry should be

rearranged and re-spun.

•  No spinning is performed when the laundry is

not evenly distributed in the drum to prevent any

damage to the machine and to its environment.

It continuously washes. Remaining time does not count down. (For models with a display)

•

 In the case of a paused countdown while taking in

water:

•  Timer will not countdown until the machine is filled

with the correct amount of water.

•  The machine will wait until there is a sufficient amount

of water to avoid poor washing results due to lack of
water. Then the timer will start to count down.

•  In the case of a paused countdown at the

heating step:

•  Time will not count down until the selected

temperature for the program is reached

•  In the case of a paused countdown at the

spinning step:

•  There may be an imbalance of laundry in the

machine.

•

 The automatic spin correction system might have been

activated due to the unbalanced distribution of the
laundry in the drum.

•  The laundry in the drum may be clustered (bundled

laundry in a bag). Laundry should be rearranged and
re-spun.

•  No spinning is performed when the laundry is not evenly

distributed in the drum to prevent any damage to the
machine and to its environment.

There is foaming over the detergent drawer

•  Too much detergent was used.

•  Mix 1 tablespoonful softener and ½ liter water and

pour into the main wash compartment of the detergent
drawer.