Sharp dv-rw2u ユーザーズマニュアル

ページ / 112
98
Recording Using an
Analog Connection with a
Digital Camcorder
VR MODE
DVD RW
 
VIDEO MODE
DVD RW
 
DVD R
Material from a digital camcorder can be recorded with this
recorder using an analog connection between this recorder
and the digital camcorder.
 NOTE
• It is recommended to use the DV IN/OUT terminal when
connecting a digital camcorder equipped with a DV
terminal. (Refer to the section on “Recording by Connect-
ing with a Digital Camcorder Using i.LINK” (page 95).)
• More vivid images can be viewed by connecting the S-
VIDEO IN jack on this recorder with the S-VIDEO OUT
jack on the camcorder using an S-VIDEO cable.
• Some camcorders may be required to be connected
using a special cable.
• Refer to the operation manual provided with the
camcorder for further information on the procedure for
connecting the camcorder.
Recording with this Recorder
1
Setup
Connect the equipment to IN 2 of this recorder.
POWER
OPEN/CLOSE
CHANNEL
TIMER ON/OFF
REC
STOP
PLAY
STILL/PAUSE
SKIP
DISC
TIMER
AV
AUTO REC
STANDBY
TIMER
DISC IN
LINE IN 2
L(MONO)-AUDIO-R
VIDEO
S-VIDEO
DV IN/OUT
RESET
To VIDEO/AUDIO
input jacks
To S-VIDEO
output jack
To VIDEO/AUDIO
output jack
To S-VIDEO
input jack
Camcorder
This recorder
Video/Audio cable
(Commercially available)
S-video cable
(Commercially
available)
Load a disc for recording in the recorder.
Connecting to Audio Equipment
2
Select the external input audio.
• Refer to the section on “EX. AUDIO” (page 86) or
the section on “D-MONO REC” (page 86).
3
Press INPUT to set to the channel of the
external input.
• The setting changes in the order of DV (DV Input),
L 1 (External Input 1), L 2 (External Input 2), L 3
(External Input 3), Channel and then back to DV (DV
Input) each time this is pressed.
4
Perform the procedure for recording with this
recorder.
 DV_RW2U#p86-99.p65
03.1.9, 7:52 PM
98