Sharp AR-5316 ユーザーズマニュアル

ページ / 80
15
BEFORE USING THE MACHINE
1
Loading the bypass tray
1
Unfold the bypass tray.
When feeding large 
paper such as 8-1/2" x 
14" and 11" x 17", pull 
out the bypass tray 
extension.
2
Set the paper guides to the copy 
paper width.
3
Insert the paper (print face down) all 
the way into the bypass tray.
To prevent a misfeed, 
verify once more that the 
paper guides are 
adjusted to the width of 
the paper.
Important points when inserting paper in the bypass tray
• Up to 100 sheets of standard copy paper can be set in the bypass tray.
• Be sure to place 5-1/2" x 8-1/2" size paper or envelopes horizontally as shown in the following diagram (
).
• When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction 
flaps (not the closure flap).
• Special papers except SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a 
time through the bypass tray.
• When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then 
reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.
• Do not use paper that is smaller than the original. This may cause smudges or unclean images.
• Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause 
smudges or unclean images. 
If you loaded paper in the bypass tray, press 
the [TRAY SELECT] key (
) to select the 
bypass tray. The bypass tray will not be 
selected automatically.
Note
Available Not available
AR-5316-5320-EX.book  15 ページ  2005年4月8日 金曜日 午前9時35分