Arkon sm5-mv5003g3 ユーザーズマニュアル

Do not install Arkon products over an air bag cover or within the air 

bag deployment zone.  Arkon Resources, Inc. assumes no responsi-

bility of liability for injury or death as a result of car crashes and / or      

air bag deployment. 
Arkon is not responsible for any damages caused to your car, your 

device, or yourself due to the installation or use of this pedestal mount.

Consumer Hotline:
USA     (800) 841-0884
INT’L    (626) 254-9005
Monday - Friday 9 am - 5 pm, PST

Step 1. 

Patent Pending

Arcadia, CA 91006 USA

Designed in USA | Made in the USA & China

© Copyright 2010 Arkon Resources, Inc.

See the included Pro.Fit VSM Bracket manual for instructions 

on installing the VSM Bracket. Arkon reccomends that you 

have the VSM bracket professionally installed. Arkon is 

not responsible for any unintended damaged caused by 

installation of the VSM Bracket.

Step 1. 

Slip the tightening ring (A) over the VSM bracket ball.  Snap 

the dual-T head adapter plate (B) on to the bracket ball 

(C).  Screw the tightening ring over the adapter plate until 

securely holding the plate.  Adjust the angle as needed.

(1) MV-50-03-G3 - Pro.Fit Vehicle Specific Mounting Bracket*

(1) SM050-HPB-2 - Slim-Grip™ Universal mobile phone holder

(1) SP-SM050-LF - Extra Long Support Legs (2 Pack) for larger phones

(1) SP-SBH-Kit - Dual-T Head with Swivel Ball Socket & Locking Ring

Step 1.

Step 1.

Connect the dual T-slots (A) on holder to the dual T-tabs (B) 

on the pedestal head.

If necessary, adjust the support legs (D) by sliding them 

laterally. These provide support for your device (sold 

seperately) .

Support the holder in place with your hand. Place device on 

the lower support legs (E) and push down with moderate 

pressure to activate the spring-loaded grip mechanism.

Slide the top of the device under the top support legs (F)

until it fits snuggly against the holder. 

Step 2.

Step 3.

MV-50-03-G3

Pro.Fit™

Vehicle Specific 

Mounting Bracket

(See included Pro-Fit

manual for instructions)

SP-SBH-Kit

Dual-T Head with 

Swivel Ball Socket & 

Locking Ring

Compatible with:
• Most non-flip style phones regardless of whether protective skin or 
sleeve (sold separately) is attached to the phone.

*See included Pro.Fit maual for Vehicle Specific Mounting Bracket instructions. For 
questions regarding installation of the Vehicle Specific Mounting Bracket, contact Pro.Fit 
directly at 800.388.0073.

A

A

B

B

C

D

D

E

F

* If necessary, install the (2) extra long support legs 

(SP-SM050-LF) to accommodate large sized phones.

88mm 

expandable to 

138mm

with Extra 

Long Support 

Legs

SM050-2 Slim-Grip™ 

Universal Phone Holder

SP-SM050-LF

Extra Long 

Support Legs

(2 Pack)