Aleratec 350103 ユーザーズマニュアル
www.aleratec.com
45
Specifications
Power Requirements
115 - 230 VAC Switchable
Dimensions
(depth x width x height)
D: 285.8mm W: 187.3mm H: 171.5mm
(7.38” x 6.75” x 11.25”)
Weight
3.36 Kilograms (7.4 Lbs.)
Note: Specifications subject to change without notice.
Troubleshooting
If your 1:1 HDD Cruiser is not performing as expected, refer to the symptoms
below, and follow the suggested corrective action.
Symptoms
Corrective Actions
LCD Display
If the LCD display does not display any message and the
backlight is not lit after powering on the 1:1 HDD Cruiser,
check that the power cable is properly connected and that
the ON/OFF switch is turned on.
Error Messages
While the system is performing an operation and the
operation is manually terminated, an error message will
be shown in the LCD display. This may lead to an failed
operation and could cause the 1:1 HDD Cruiser to stop
responding. If this happens, power the unit off, wait about
ten (10) seconds, and then reapply power.
Hard Disk
If the 1:1 HDD Cruiser does not detect one of the hard
disk drives, verify that the drive is properly seated in the
drive bay.
Keypad Buttons
If pressing the keys on the front panel produces no
response from the system, the 1:1 HDD Cruiser may still
be busy with the previous operation. If the system idle,
power the unit off, wait about ten (10) seconds, and then
reapply power.
Firmware Update
The device can be updated to new versions of firmware
via a DVD/CD drive. If unable to update the firmware,
check that the firmware was downloaded correctly. A
failed firmware upgrade may cause the 1:1 HDD Cruiser
to become inoperable. If the system is working normally,
do not attempt this operation. If the system is already
experiencing problems, please contact Aleratec for repairs.
Startup/Shutdown
Do not power off the system while it is performing an
operation. After a normal shutdown, wait about ten (10)
seconds before reapplying power.