HP Compaq KB-9965 311059-061 ユーザーズマニュアル

Refer to the HP Servers Troubleshooting Guide for the following: 

• 

• 
• 

Information you need to collect when diagnosing software problems and to provide when 
contacting support 

Instructions on how to upgrade the operating system and its drivers 

Information about available recovery options and advice on minimizing downtime 

A corrupted system ROM requires that you recreate the ROM BIOS by a process called 
disaster recovery. This operation can be accomplished only when the system is in disaster 
recovery (emergency repair boot) mode. When both system ROMs are corrupt, the system 
defaults into disaster recovery mode automatically and the server emits two extended beeps. 

 

  Before performing this operation, refer to the HP Servers Troubleshooting Guide for 

complete instructions on disaster recovery. 

To perform ROMPaq disaster recovery: 

1.  Power down the server. 

2.  Set system maintenance switches 1, 4, 5, and 6 to the “on” position. For the location of 

these switches, refer to Chapter 4, “Connectors, LEDs, and Switches.” 

3.  Power up the server. After the system powers on, it repeatedly emits two long beeps. 

4.  Power down the server again. If necessary, perform a forced shutdown by pressing the 

power button for 4 seconds. 

5.  Set system maintenance switches 1, 4, 5, and 6 back to the default position (off). 

6.  Power up the system. 

7.  Insert a ROMPaq diskette with the latest system ROM that you have downloaded from 

www.hp.com

 

 

  The ROMPaq will flash both sides of the redundant ROM. This process may take 

up to 10 minutes. 

8.  Wait until the server emits three rising beeps, indicating the completion of the ROM flash 

process. 

9.  Restart the server.