Siemens siemens network router mc35 ユーザーズマニュアル
Remote-SAT User's Guide
MC35_SAT_01_v02.00
Page 34 of 65
11.01.2002
1.4.11 AT^SSTGI Remote-SAT Get Information – Get Inkey (34)
Write command
AT^SSTGI=34
This command is to be used upon receiving an unsolicited result code
^SSTN:34.
^SSTN:34.
The TA is asked to prompt the user for an input, which is a single character.
Help can be requested by the user, if available.
Help can be requested by the user, if available.
Text and an Icon Identifier can be passed to the TA to display to the user.
Response
^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId>
<CR> <LF>
<CR> <LF>
Parameters
<cmdType>
34 – Proactive command ID, see Table 1
<commandDetails>
Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1:
bit 1:
0 = digits (0-9, *, # and +) only
1 = alphabet set;
1 = alphabet set;
bit 2:
0 = SMS default alphabet (GSM character set)
1 = UCS2 alphabet
1 = UCS2 alphabet
bit 3:
0 = character sets defined by bit 1 and bit 2 are
enabled
1 = character sets defined by bit 1 and bit 2 are
disabled and the "Yes/No" response is
requested
enabled
1 = character sets defined by bit 1 and bit 2 are
disabled and the "Yes/No" response is
requested
bits 4-7: = RFU
bit 8:
bit 8:
0 = no help information available
1 = help information available
1 = help information available
<text>
String as prompt for text.
<iconQualifier>
Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1:
bit 1:
0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
<iconId>
0-255, 0: no icon
Reference
Siemens
Note