Shark gi468cn 12 ユーザーズマニュアル

 1-800-798-7398

Steam burst helps to 
remove stubborn wrinkles 
and can work both 
horizontally and vertically. 

  Make sure the water tank is at least 1/2 

 

filled with water.

  Select the desired fabric and tempera-

 

ture setting after reading the garment 

 

label.

  Place the iron on its heel, standing up 

 

on a stable and protected surface so it 

 

can heat up for approximately 2 

 

minutes.

  Press the steam burst button while

 

holding the iron horizontally or 

 

vertically. Give an interval of 3 

 

seconds of each burst. Overuse of 

 

steam burst button may cause water 

 

spitting or weak steam performance.

  Always empty the water in the iron 

 

after each use.

When you have finished ironing, turn 

 

the variable steam control lever to “0” 

 

and press the electronic temperature 

 

control button until the power light is 

 

lit.

  Unplug the iron from the electrical 

 

outlet.

  Turn the iron upside down over the 

 

sink with the tip pointing downward 

 

and allow the water to flow from the 

 

opening. Be cautious when emptying, 

 

don’t touch the hot surfaces, water or 

 

steam because injury may occur.

  Place the iron upright and allow to 

 

cool before storing.

The Shark

®

 Rapido™ Electronic Iron is 

equipped with an electronic auto-off 
feature. The electronic auto-off 
switches the iron off if it has been 
unmoved in any position (sideways, 
flat or upright) for approximately 7-9 
minutes. The auto-off light will turn red 
on the LED display panel when the iron 
switches off. To turn the iron back on, 
just gently rock the iron back and forth 
several times until the “Power ON” 
light is re-illuminated. Press the 
Electronic Temperature Control to 
reset the temperature to the desired 
setting. The iron might have to warm 
up for a minute if the auto-off feature 
was activated for an extended time. 

  The steam burst feature is especially 

 

useful to remove wrinkles from 

 

hanging clothes, delicate garments 

 

and other fabrics. Hold the iron in a 

 

vertical position several inches away 

 

from the articles and press the steam 

 

burst button to prime the pump.

 

CAUTION: Do not aim iron at yourself 

 

or anyone else while using the steam 

 

burst feature. Be careful, burns or 

 

serious injury may occur.

CAUTION: Never iron or steam 

 

clothes while they are being worn.

 

If the tank runs dry, always make sure 

 

you unplug the iron from the outlet 

 

before you refill.