AstroStart 5204u ユーザーズマニュアル

This type of antitheft system arms automatically when ignition key is turned from RUN to OFF and remains OFF for one 
minute. It can also be armed manually by sending a Lock command (unless ignition key is in RUN position).  

Antitheft system is disarmed for one minute when you send an Unlock command. If ignition key is not turned to RUN 
position within one minute, system automatically rearms, thus preventing an intruder from starting your vehicle, even with 
ignition key.  
It can be connected so that horn sounds if an intruder tries to start your vehicle when antitheft is armed. 

This type of antitheft system is armed by sending a Lock command (unless ignition key is in RUN position) and is disarmed 
by sending an Unlock command. 

(Antitheft) 

The Antitheft function can be deactivated for the same reasons and in the same way as the Antitheft system. See "Valet 
mode" details on page 14. 

These commands allow you to control most of the vehicle accessories depending on what was connected during installation 
(headlights, defroster, etc.). For more information, check with your technician. 
To activate these functions, simultaneously press  the buttons as shown in the following table.  

The accessory associated to each of these commands is activated for the duration set at time of installation.  
The delay can be canceled by repeating the command.  

Press 

 and 

 buttons simultaneously.  

This function sounds the horn (short melody) and flashes the parking lights so you can locate your vehicle in a large 
parking lot.  

The remote can be programmed to be used in silent mode.    
Refer to the following table to select the necessary command.  
The mode is de/activated the same way (except for the alarm and the pre-shock).  

The keypad of your remote can be locked to prevent any unwanted commands to be sent 
to your vehicle. 
The mode is de/activated the same way.  

 

Refer to the following table to select the necessary command. 

Remote control 

4-button 5-button  6-button 

Corresponding accessory 

Duration 

UTILITY 1 

 

 

 

 

 

 

 

 

UTILITY 2 

 

 

 

 

 

UTILITY 3 

- -   

 

 

 

UTILITY 4 

- -  

 

 

 

 > 5 sec. 

 

 

 

 

 > 5 sec.