Sharp JW-20FLT ユーザーズマニュアル
15-31
Chapter 15: Appendix
15
Installation of a tap in the main case of a transceiver
Transceiver (tap type)
To connect a tap type transceiver to a coaxial cable, make a hole in the coaxial cable insulation and
insert a probe that will make contact with center conductor in the coaxial cable. Remove the insula-
tion around the coaxial cable using a special tool.
Supply power from a node to the transceiver (12 VDC) using a transceiver cable. Some nodes may
require a separate 12 VDC power supply in order to use the transceiver cable. For details, see the
hardware manual for your node.
The "SQE" switch setting on a transceiver is made as follows.
1. ON when connected to a node.
2. OFF when connected to a repeater.
insert a probe that will make contact with center conductor in the coaxial cable. Remove the insula-
tion around the coaxial cable using a special tool.
Supply power from a node to the transceiver (12 VDC) using a transceiver cable. Some nodes may
require a separate 12 VDC power supply in order to use the transceiver cable. For details, see the
hardware manual for your node.
The "SQE" switch setting on a transceiver is made as follows.
1. ON when connected to a node.
2. OFF when connected to a repeater.
Transceiver (tap type) for Ethernet cable
M6 bolts 141
LAN transceiver
Tap connector
Coaxial cable
Transceiver cable
(AUI cable)
Transceiver
AUI connector
D-sub 15-pin
D-sub 15-pin
12 VDC
external
power
supply
When using an AUI external
power input terminal block
12 VDC (depends on the
model used)
power input terminal block
12 VDC (depends on the
model used)