Phihong POE60U-560G プリント
POE60U Characteristics
WWW.PHIHONG.COM
INPUT:
EMC
AC Input Voltage Range
FCC Part 15 Class B
90 to 264VAC
EN55022 Class B
AC Input Voltage Rating
Isolation Test
100 to 240VAC,47-63Hz
Primary to Secondary: 3000VAC for 1 minute 10mA
Primary to F.G.: 1500VAC for 1 minute
Primary to F.G.: 1500VAC for 1 minute
AC Input Current
Output to F.G.: 1500VAC
1A(RMS) max. for 90VAC
0.7A(RMS) max. for 240VAC
Immunity
ESD:
EN61000-4-2. Level 3
Leakage Current
RS:
EN61000-4-3. Level 2
0.25mA max. @ 254VAC 60Hz
EFT:
EN61000-4-4. Level 2
Surge:
EN61000-4-5. Level 3
AC Inrush Current
CS:
EN61000-4-6. Level 2
15A(RMS) max. for 115VAC
Voltage Dips
EN61000-4-11
20A(RMS) max. for 230VAC
Harmonic: EN61000-3-2
OUTPUT:
Insulation Resistance
Total Output Power
Primary to secondary: >10M OHM 500VDC
60W
Primary to FC: >10M OHM 500VDC
DC Offset
FEATURES:
No Data degradation with DC imbalance 18mA per min.
Detection
Same as IEEE802.3af except 12.5kohm detection
resistor value required at Powered device.
resistor value required at Powered device.
Efficiency
65% (typical) at Max. load, and 120VAC 60Hz
Over Voltage/Current, Short Circuit Protection
Hold-up Time
Outputs equipped with short circuit protection and overload
protection as per 802.3af specification except max average
current is 0.55A, Peak 0.6A per pair
protection as per 802.3af specification except max average
current is 0.55A, Peak 0.6A per pair
16mS min. 120VAC and max. load
Transient O/P Voltage Protection
The output can be shorted permanently without damage
60V max.
Indicators
ENVIRONMENTAL:
Led #1 indicator for input power “on” GREEN
Temperature
Led #2 Indicator for fault-RED
Operation
0 to +40°C
Led #3 Indicator that Detected and Connected to valid
IEEE802.3af load-GREEN
IEEE802.3af load-GREEN
Non-operation
-25 to +65°C
Humidity
Input Connector
Operation
5 to 90%
IEC320 inlet 3 pin
Dimension Diagram Unit: mm (inch)