Ariston a1200wd ユーザーズマニュアル

Once the appliance has been installed and before you
use it for the first time, run a wash cycle without 
detergent and no laundry, setting the 90˚C 
programme without a pre-wash cycle.

A1600WD, A1400SWD, 
A1400WD, A1200WD

59.5cm wide

85cm high
60cm deep

from 1 to 6kg

voltage 220/240 Volts  50Hz

maximum absorbed power:
1700W-2100W

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)
drum capacity 53 litres

up to 1600 rpm -  A1600WD
up to 1400 rpm -  A1400SWD, 

A1400WD

up to 1200 rpm -  A1200WD

programme 3

temperature 60˚C

dry run with a 1kg load followed by 

a 5kg load for model A1600WD

dry run with a 2kg load followed by 
a 4kg load for models A1400SWD,
A1400WD and A1200WD

This appliance is compliant with the
following European Community
Directives:

- 72/23/CEE of 19/02/73 
(Low Voltage) and subsequent amendments.
- 89/336/CEE of 03/05/89 (Electromagnetic
Compatibility) and subsequent amendments.

A. Connect the drain 
hose, without kinking it, 
to a draining duct or a 
wall drain fixed at a 
height between 65 and 
100cm from the floor. 
Use the curved bracket,
if reqired.

B. Alternatively, place 
it over the edge of a 
basin, sink or tub, 
fastening the hose 
supplied to the tap.  

!

The free end of the hose should not be under water.

!

We advise against the use of hose extensions. In

case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150cm in length.

Before plugging the appliance into the mains socket,
make sure that:

●

the socket is earthed and in compliance with the 
applicable law.

●

the socket is able to sustain the appliances 
maximum power load indicated in the Technical 
Details table (

).

●

the supply voltage is included within the values 
indicated in the Technical Details table (

).

●

the socket is compatible with the machines plug.  
If this is not the case, replace the socket or the 
plug.

!

The machine should not be installed in an outdoor

environment, not even when the area is sheltered,
because it may be very dangerous to leave it exposed
to rain and thunderstorms.
!

When the machine is installed, the mains socket

must be within easy reach and should be connected
to a suitable electrical supply.
!

Do not use extensions or multiple sockets.

!

The power supply cable must never be bent or dan-

gerously compressed.
!

The power supply cable must only be replaced by

an authorised serviceman.
!

The company denies all liability if and when these

norms are not respected.