Allied Telesis at-gs950-16 ユーザーズマニュアル

How to Start an AT-GS950/16 WEB Management Session

43

This procedure returns all AT-S108 Management software parameters to 
their default values and deletes all tagged and port-based VLANs on the 
switch. 

This procedure causes the switch to reboot. The switch does not forward 
network traffic during the reboot process. Some network traffic may be 
lost. 

To return the AT-S108 Management software to the default settings, do 
the following procedure:

1. From the Tools folder, select Reboot.

The Reboot Page is shown in Figure 14 on page 32.

2. For the Reboot Type field, use the pull-down menu to select one of 

the following:

Factory Default
Resets all switch parameters to the factory default settings, including 
the IP address, subnet mask, and gateway address.

Warning
This setting will cause the IP address to be reset to 192.168.1.1. You 
will loose connectivity with the switch management software after 
the reboot is completed

Factory Default Except IP Address
Resets all switch parameters to the factory default settings, but retains 
the IP address, subnet mask, and gateway settings. If the DHCP client 
is enabled, it remains enabled after this reset.

3. For the Reboot Status field, use the pull-down menu to select Start to 

begin the reboot.

4. Click Apply.

The switch is rebooted. You must wait for the switch to complete the 
reboot process before establishing your management session again.