Epson network card cpd5719 ユーザーズマニュアル

After you install the Ethernet card in a printer or reinstall it in a new

printer, plug in the printer while pressing down the status sheet

button for at least three seconds to initialize the card.

status sheet button

You can print a status sheet after you finish initializing the card.

Turn on the printer and press the status sheet button. The status

sheet gives you information about the Ethernet card including the

current configuration, serial number, and address of the card. Keep

the status sheet; you need the information to configure the card.

If you use the Ethernet card in a NetWare environment over a WAN

(Wide Area Network) and connect it to a general phone line

(including ISDN), the card may open the dial-up-router and packets

may be sent to the WAN. To avoid this problem and possible phone

fees, mask the vendor code in the dial-up-router as shown below:

Vendor code

For details on how to mask the vendor code, ask your network

administrator or see your NetWare documentation.

Before configuring the Eth

printer driver is installed i

turned on and the Etherne

your Ethernet card 

more information.)

The information on 

sections:

Cl Installing EPSON Net!

 Monitoring the 

 Configuring the Ether:

 Configuring the Ether:

for Macintosh

To install EPSON Net! for

Turn on your 

2. Create a folder for 

3. Insert the EPSON Net!

4. Copy the program 

You can monitor and 

your network according tc