Sharp MX-2300G ユーザーズマニュアル

This chapter explains how to place originals in the automatic document feeder and on the document glass.

This section explains how to place originals in the automatic document feeder.

When a non-standard size original is placed in copy mode, see "SPECIFYING THE ORIGINAL SIZE" in the Copier 
Guide.
When a non-standard size original is placed for a fax or scanner transmission, see "SPECIFYING THE SCAN SIZE OF 
THE ORIGINAL" in the Facsimile Guide or Scanner Guide.
Allowed original weights
1-sided copying: 35 g/m

2

 to 128 g/m

2

 (9 Ibs. to 34 Ibs.)

2-sided copying: 50 g/m

2

 to 105 g/m

2

 (15 Ibs. to 28 Ibs.

)

To scan originals from 35 g/m

2

 to 49 g/m

2

 (9 Ibs. to 14 Ibs.), use "Slow Scan Mode" in the special modes. Scanning 

without using "Slow Scan Mode" may result in original misfeeds.
When "Slow Scan Mode" is selected, automatic two-sided scanning is not possible.

Standard sizes
(minimum size that can be automatically detected)
A5: 210 mm (width) x 148 mm (length)
8-1/2" (width) x 5-1/2" (length)
Non-standard sizes
(minimum size that can be specified manually)
131 mm (width) x 143 mm (length)
5-1/8" (width) x 5-3/4" (length)

Standard sizes
(maximum size that can be automatically detected)
A3: 297 mm (width) x 420 mm (length)
11" (width) x 17" (length)
A3W (12" x 18" size paper) cannot be used.
Non-standard sizes
(maximum size that can be specified manually)
Copy mode: 297 mm (width) x 432 mm (length)
In image send mode, up to 297 mm (width) x 800 mm (length) 
is possible.

Open the automatic document feeder, make sure that an 
original is not on the document glass, and then gently close the 
automatic document feeder.